More Monitor Creep

Or... Enjoying the World of Aging Gear




Here's one for those who enjoy the granular side of recording studio work.

11/12/2026

I'm sitting in a recording studio that was built in 1996. There was an upgrade in 1999 where we did some architectural improvements and replaced some of the gear with top-of-the-line stuff. In that upgrade we replaced the monitor amplifiers with David Haffler TransNova amps and the room EQs with Klark Teknik DN360 dual channel third-octave room EQs. We corrected the monitors with the room EQs and a real time analyser program, using mostly little 3-4db tweaks.

In a previous article HERE I discussed an overdrive distortion that crept into the right Haffler amp of the main monitor array. We replaced the amp with a spare from another control room and all was well. For a while. Then in the last three weeks I noticed a tiny bit of hum coming from the other monitor. It grew over time so I decided it was time to take action. I patched around and eliminated the mixing console as the problem and patched further and eliminated the amplifier and then decided it was time to bring in my friend Joe from the engineering shop to help. Between the two of us we did further sleuthing and isolated the hum to the Klark Teknik room EQ for the main monitors. As it happens, I own a personal DN360 room EQ that I keep tucked away in a drawer (why?), so I pulled it out, eyeballed the settings, and Joe and I replaced the main monitor EQ with it. Joe took the studio's unit to the engineering shop and dived in.

With the studio unit on the bench and the trim cover off we immediately saw a pair of filter caps in the power supply with slightly bulging expansion ends. They were probably toast but it was no problem. Joe replaced them from stock on hand, checked the output with the oscilloscope, and closed up the box. Back in the studio's machine room we re-mounted the EQ. When we powered up the system, however, there was a huge crackle and a strange buzz around 480hz. Joe took it back to the shop, pulled it apart and checked everything again. There was no obvious problem. With the dress cover off and some of the circuit boards out of the box but still connected, the buzz was gone. Hmmm. He reassembled it a board at a time, checking at each step, and was able to get it together and working cleanly. Something must have been squeezed in that first reassembly. Back in the rack it went and we were back in business, the monitors smooth and clean.

So, that's a little bit about why and how things are handled in our plant. It is good to have an engineer (licensed broadcast engineer) in the house who is also a friend. He's a great guitarist and bassist as well, so we have a lot to talk about. It's also wonderful to have power screwdrivers. Wow, that has changed our world. In and out of the rack is a breeze. And, of course, it is also wonderful to have a spare unit to slide in while we are working on the primary.




==